Order 7 - Royale Crown | Car Mechanic Simulator 2018 Walkthrough Car Mechanic Simulator 2018 Guide

The seventh order in Car Mechanic Simulator 2018 requires you to work on another Royale Crown. This chapter contains a detailed walkthrough of this task. Here, you will find a list of parts you have to replace and a description of the repairing process.

• Shopping list
• Walkthrough

Shopping list

A (quite long) list of parts:

Front:

1. Lower Suspension Arm
2. Inner Tie Rod x2
3. Outer Tie Rod x2
4. Front Axle Knuckle Cover
5. Front Steering Knuckle A
6. Steering Rack

Rear:

1. Rear Suspension Arm
2. Rear Suspension Arm A
3. Rear Suspension Arm B
4. Sway Bar Rear
5. Rear Shock Absorber A
6. Rear Sway Bar A
7. Rear Axle Knuckle Housing A
8. Wheel Hub 3
9. Rubber Bushings x3
10. Small Rubber Bushings x2

Drive and Gearbox:

1. Front Drive Axle C x2
2. Front Drive Shaft
3. Clutch Pressure Plate
4. Flywheel
5. Clutch Plate
6. Gearbox (I4)

Brakes:

1. Brake Caliper
2. Brake Pads x4

Cooling System:

1. Radiator Fan Housing
2. Radiator Fan

Walkthrough

If your task is to remove the gearbox, start by dismantling the starter, as V8 engines have starters accessible from the bottom of the car)

This job becomes active once you've reached level 7. Your task is to perform a large number of repairs including braking, suspension, drive, and cooling systems. Use the Test Track and Test Path to receive the list of all mechanical faults.

The bushings in the rear axle are often overlooked

Remove the wheels and the braking systems. Approach the front left wheel and dismantle all suspension elements - do the same with the right rear wheel. Switch to the front of the vehicle and dismantle the drive axles, the whole gearbox and finally, the clutch. Don't forget about the starter (removable from the engine view when the vehicle is on the ground) - removing this part is mandatory if you want to disassemble the gearbox. Repair both the radiator fan and the radiator itself.

Tip: You can easily detect the damaged suspension elements by using the Examine Mode which shows the durability of each of the elements and informs you if a given part needs to be replaced - if the latter is true, the part will be marked in red.