Order 63 - Genesis Town | Orders - Third garage Car Mechanic Simulator 2014 Guide

CAR: Genesis Town

TARGETS:

1. Repair or replace worn out parts
2. Perform Chip Tuning min. 10%

REWARD: 3000 USD

PARTS:

• Alternator - repair ca. 240 USD, new part 500 USD
• 4x Spark Plug - 120 USD
• Ignition Wires - 150 USD
• Ignition Module - 750 USD
• Starter - repair ca. 90 USD, new part 200 USD
• Timing Belt - 120 USD
• Serpentine Belt - 100 USD
• Belt Tensioner - 150 USD

Your client has tried the engine tuning in special offer but instead of saving money, he will lose it - many components located around the engine has been damaged during the process. Perform all necessary tests (OBD Test, Test Drive) and turn on the Show parts conditions mode. Following parts require a quick service:

• Alternator
• 4x Spark Plug
• Ignition Wires
• Ignition Module
• Starter
• Timing Belt
• Serpentine Belt
• Belt Tensioner

Purchase (or repair - that applies to Alternator and Starter) all elements and start the realization of the order:

Alternator, timing belt, serpentine belt, belt tensioner:

1. Go to the Engine - inspect view mode when the car stands on the ground.
2. Remove Serpentine Belt.
3. Twist off and remove Alternator and then assemble a new one.
4. Remove Belt Tensioner.
5. Remove Timing Belt and replace it with a new one.
6. Assemble new Belt Tensioner.
7. Assemble new Serpentine Belt.

With conditions like this, it's hard for car to function correctly.

Ignition wires, ignition module, spark plugs:

• Remove Plastic Engine Cover.
• Unplug Ignition Wires.
• Twist off Ignition Module and replace it with a new part.
• Twist off all four Spark Plugs and replace them with new parts.
• Assemble new Ignition Wires.
• Assemble Plastic Engine Cover.

Starter:

• Raise Hood and go to the Engine - inspect view mode.
• Turn on the Disassemble Mode.
• Disassemble Starter located in the engine's rear and place a new one.

The last step is to increase car's power by at least 10% - in that order perform the chip tuning. Go to the proper room with the Roller Dyno - tune car option and start the tuning application - Program Eeprom.