Order 6 - Aisan Cougar | Orders - First garage Car Mechanic Simulator 2014 Guide

CAR: Aisan Cougar

TARGETS:

1. Perform a test drive
2. Replace all damaged parts

REWARD: 1000 USD

PARTS:

• Clutch Release Bearing - 500 USD
• Clutch Friction Plate - 100 USD

Client is complaining about straitened work of the gearbox - it is definitely harder to change gears than it was before. Unfortunately, it is not known which elements have been damaged but your client suspects that problems with the clutch are guilty.

To gain access to the gearbox you need to twist off both drive axles.

Solving the problem begin with performing the test drive - after doing that pick the Examine Conditions mode and take a look under the hood. If client has mentioned the clutch it is time to check it's elements - but before you will be able do to that you need to remove also the gearbox. It's disassemble is a little bit more complicated:

• Go to the Wheel - inspect view mode.
• Turn on the Disassemble Mode.
• Twist off Aisan Cougar Left Wheel.
• Twist off and remove Brake Caliper.
• Remove both Brake Pads.
• Remove Brake Disc.
• Twist off Drive Axle Left.

Clutch release bearing is one of the two problematic elements.

Repeat the same actions with the right wheel. Then make another steps:

1. Raise Hood and go to Engine - inspect view mode.
2. Turn on the Disassemble Mode.
3. Twist off and remove Starter placed in the rear part of the engine.
4. Twist off and remove Gearbox.

As you can see, replace with the new item is necessity.

Below we can see clutch elements - we remove damaged Clutch Release Bearing and broken Clutch Friction Plate. Go to the computer in order to buy new parts and put them into the car by turning on the Assemble Mode. Then screw and assemble Gearbox, Starter and the rest of the removed suspension's elements.